Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KCS firmware
#11
(09-18-2024, 07:55 PM)remiasz Wrote: Where to connect HC-SR04? It works on 5V and HT ports on 3V.
Maybe it's better to use 433M interface? 433M_T signal as trigger and DATA_R as echo. There is also 5V power supply on connector P2.
How to set PIN parameter?

Yes, HC-SR04 sensor output signal level is 5V or 0V. you can connect with 433MHz receiver data pin on PCB, that is 5v level.
Reply


Messages In This Thread
KCS firmware - by remiasz - 09-08-2024, 05:28 PM
RE: KCS firmware - by admin - 09-09-2024, 12:32 AM
RE: KCS firmware - by remiasz - 09-13-2024, 02:05 PM
RE: KCS firmware - by admin - 09-13-2024, 10:11 PM
RE: KCS firmware - by remiasz - 09-15-2024, 02:02 PM
RE: KCS firmware - by admin - 09-15-2024, 11:55 PM
RE: KCS firmware - by remiasz - 09-16-2024, 08:55 PM
RE: KCS firmware - by admin - 09-16-2024, 11:37 PM
RE: KCS firmware - by remiasz - 09-18-2024, 07:55 PM
RE: KCS firmware - by remiasz - 09-18-2024, 08:55 PM
RE: KCS firmware - by admin - 09-18-2024, 11:48 PM
RE: KCS firmware - by xxpeta - 10-06-2024, 04:12 PM
RE: KCS firmware - by admin - 10-07-2024, 01:07 AM
RE: KCS firmware - by xxpeta - 10-07-2024, 07:27 AM
RE: KCS firmware - by admin - 10-07-2024, 07:55 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)