SHT30/DS18B20 errors and warnings in the logs

[TaurosRMK]

I've been running tests for a while and have figured out something. The Kincony A2 board works fine with the DS18B20 sensor if A2 is not in the control box. Even if I put the board in the box where it should be, everything works fine until I start the fans. A 0-10V signal controls these fans, and the controller is connected to the Kincony A2 via RS485. The Kincony A2 also reads the RPM of these fans.

Is there any interference or conflict between the 0-10V controller and the Kincony A2? Maybe the Kincony A2 is not protected against interference? Is there any way to fix it?