KCS: Add ability to turn off saving output state to NVS?

[stian]

Hi thank you for taking the time to add the screenshot. This was one of the things I tried initially but as far as I can tell it will still persist the state to NVS. E.g. whether or not output 1, 2 etc is enabled or disabled (or whenever the state changes). I made some good progress with my own firmware so I think I might cover my own needs for now.

Quick question, are there any free GPIO pins available for UART? I think I can use the pins used for the 433 MHz receiver & transmitter (respectively)?


Thank you again for taking the time to answer me, I really appreciate it. Love your products!