Smart Home Automation Forum › Technical Support › KC868-A series and Uair Smart Controller v
KCS: Add ability to turn off saving output state to NVS?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
KCS: Add ability to turn off saving output state to NVS?
stian Offline
Junior Member
**
Posts: 4
Threads: 1
Joined: Nov 2024
Reputation: 0
#7
11-06-2024, 02:00 PM
(11-06-2024, 08:03 AM)admin Wrote: if you are using KC868-A16, 433M sender can use as free GPIO. But also there are 3 free GPIOs you can use for serial port.

Great, Where are the are the other 3 GPIO ports located?
Find
Reply


Messages In This Thread
RE: KCS: Add ability to turn off saving output state to NVS? - by stian - 11-06-2024, 02:00 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)