12-09-2024, 08:39 PM
Hello,
I have purchased the KC868-A16 ESP32 board, and I plan to use it for electrical automation in the process of converting a bus into a camper. The KCS firmware seems to fit quite well, but I have a few questions:
Is it possible to separate the Monitor from the administrative part? Specifically, I would like to run just the control system with monitoring functionality, without the rest. The idea is to have the Monitor accessible within the network without requiring login.
Is it possible to map the remote control of a VEVOR Webasto device? The remote is bidirectional and provides feedback on the device settings.
If I need to write my own program, is there any way to extract the mapped settings from the remote control?
Thank you!
I have purchased the KC868-A16 ESP32 board, and I plan to use it for electrical automation in the process of converting a bus into a camper. The KCS firmware seems to fit quite well, but I have a few questions:
Is it possible to separate the Monitor from the administrative part? Specifically, I would like to run just the control system with monitoring functionality, without the rest. The idea is to have the Monitor accessible within the network without requiring login.
Is it possible to map the remote control of a VEVOR Webasto device? The remote is bidirectional and provides feedback on the device settings.
If I need to write my own program, is there any way to extract the mapped settings from the remote control?
Thank you!