|
ESP32 S3 set up issue
|
12-13-2024, 06:40 AM
In a previous post I mentioned that I am using the SIM 7600 module with the ESP32 S3 WROOM 1U, however I can't use the serial monitor in order to receive information (I can't see data), I can upload the firmware to ESP32 but after upload the firmware I can't see a response in serial monitor, I only can see the failures that I sent in previos post after Enabled the "USB CDC On Boot''.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
ESP32 S3 set up issue - by omarzamudio - 12-12-2024, 05:35 PM
RE: ESP32 S3 set up issue - by admin - 12-13-2024, 01:21 AM
RE: ESP32 S3 set up issue - by omarzamudio - 12-13-2024, 02:20 AM
RE: ESP32 S3 set up issue - by admin - 12-13-2024, 03:35 AM
RE: ESP32 S3 set up issue - by omarzamudio - 12-13-2024, 06:40 AM
RE: ESP32 S3 set up issue - by admin - 12-13-2024, 07:41 AM
RE: ESP32 S3 set up issue - by omarzamudio - 12-13-2024, 05:58 PM
RE: ESP32 S3 set up issue - by admin - 12-14-2024, 01:22 AM
RE: ESP32 S3 set up issue - by omarzamudio - 12-14-2024, 06:15 AM
RE: ESP32 S3 set up issue - by omarzamudio - Yesterday, 01:17 PM
RE: ESP32 S3 set up issue - by admin - Yesterday, 11:43 PM
|
| Users browsing this thread: |
| 1 Guest(s) |
