Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KC868-A8 Schematic
#5
Thank you. Sure, this is the same for 1.6 ? I connected my PIR to S3 but i got the signal on GPIO32. I use tasmota with this config:

{"NAME":"KC868-A8","GPIO":[32,0,1120,0,640,608,0,0,0,1,1,1152,0,0,5600,0,0,0,0,5568,0,0,0,0,0,0,0,0,1,1,0,0,1,0,0,1],"FLAG":0,"BASE":1}
Reply


Messages In This Thread
KC868-A8 Schematic - by DarthWeber - 12-13-2024, 05:33 AM
RE: KC868-A8 Schematic - by admin - 12-13-2024, 05:38 AM
RE: KC868-A8 Schematic - by DarthWeber - 12-13-2024, 06:02 AM
RE: KC868-A8 Schematic - by admin - 12-13-2024, 06:11 AM
RE: KC868-A8 Schematic - by DarthWeber - 12-13-2024, 11:56 AM
RE: KC868-A8 Schematic - by admin - 12-14-2024, 01:11 AM
RE: KC868-A8 Schematic - by tanoshimi - 12-17-2024, 11:27 AM
RE: KC868-A8 Schematic - by admin - 12-17-2024, 11:40 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)