change wake up name

[gal]

KCS firmware not support wiegand directly, maybe in future will update for that.
now you can config by ESPHome, if you want to use wiegand device. any free GPIOs can be used by wiegand device.

Hi
I have edited the yaml for the wiegand as attached and has failed to download please see below , I have tried to rename 47 ,48 but still didnt work and deleted them still didnt work ....I dont know what to do..
And just to let you know about the kc868 aio yaml you are going to do for me for the sensors, I have 3 water level sensors, 3 temperature and humidity sensors, 2 human sensors and 3 water temperature sensors . if that helps.
Many thanks.


      open_drain: False
      pullup: False
      pulldown: False
    ignore_pin_validation_error: False
binary_sensor.gpio: [source /config/esphome/kincony-b16m.yaml:585]
 
  Pin 47 is used in multiple places.
  platform: gpio
  name: b16m-W1-io47
  pin:
    number: 47
    inverted: True
    mode:
      input: True
      output: False
      open_drain: False
      pullup: False
      pulldown: False
    ignore_pin_validation_error: False
wiegand: [source /config/esphome/kincony-b16m.yaml:652]
 
  Pin 48 is used in multiple places.
  - [source /config/esphome/kincony-b16m.yaml:652]
    id: mykeypad
    d0:
      number: 48
      mode:
        input: True
        output: False
        open_drain: False
        pullup: False
        pulldown: False
      inverted: False
      ignore_pin_validation_error: False
Pin 47 is used in multiple places