Smart Home Automation Forum › Technical Support › KC868-A8 v
Kc868 a8 in workshop

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Kc868 a8 in workshop
admin Offline
Administrator
*******
Posts: 6,874
Threads: 848
Joined: Oct 2020
Reputation: 169
#8
12-25-2024, 10:53 PM
1. connect with DHT22 sensor, but DHT22 need useby 5v VCC, not 3.3v. you can connect to RF receiver or RF sender module's socket pin, there is 5V pin.
2. config sensor in KCS webpage, then will be work well.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com
Find
Reply


Messages In This Thread
Kc868 a8 in workshop - by Verresen - 12-19-2024, 06:22 PM
RE: Kc868 a8 in workshop - by admin - 12-20-2024, 12:25 AM
RE: Kc868 a8 in workshop - by Verresen - 12-21-2024, 03:21 AM
RE: Kc868 a8 in workshop - by Verresen - 12-21-2024, 03:28 AM
RE: Kc868 a8 in workshop - by admin - 12-21-2024, 05:07 AM
RE: Kc868 a8 in workshop - by Verresen - 12-21-2024, 05:20 AM
RE: Kc868 a8 in workshop - by Verresen - 12-25-2024, 03:15 PM
RE: Kc868 a8 in workshop - by admin - 12-25-2024, 10:53 PM
RE: Kc868 a8 in workshop - by Verresen - 12-26-2024, 05:53 AM
RE: Kc868 a8 in workshop - by admin - 12-26-2024, 08:18 AM
RE: Kc868 a8 in workshop - by Verresen - 12-26-2024, 08:51 AM
RE: Kc868 a8 in workshop - by admin - 12-26-2024, 10:29 AM
RE: Kc868 a8 in workshop - by Verresen - 12-26-2024, 11:10 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)