01-09-2025, 12:08 AM
(01-08-2025, 11:19 PM)admin Wrote: the new KC868-A6 board have our test firmware. you can download KCS v2 firmware to use or config by ESPHome.
1: use by KCS v2 firmware , here is online guide: https://www.kincony.com/esp32-kcsv2-firmware.html
2. config by ESPHome, here is yaml file for KC868-A6: https://www.kincony.com/forum/showthread.php?tid=1963
No, as I said, this isn't going to work:
- your online guide recommends a Windows program for ESP32 programming. I don't have Windows. Also, *THE BOARD IS NOT FOUND WHEN USB IS CONNECTED*. I was hoping that someone could tell me a thing to do when that happens - most ESP32 boards just show up when USB is plugged in, but not yours. Am I supposed to do something special? I don't see anything like that in your "guides". I have applied +12V (the board powers on) and plugged in USB-C, but NOTHING show up on computer.
- I would use WiFi to change firmware, but the device does not show up with WiFi scan - No AP at all.
I suspect either the USB port is damaged (though I have two boards, both have the same problem) or I will need to do something else.
Is there a way to upload firmware over serial? Which serial do I need to use?