01-13-2025, 01:44 AM
Connecting the 0-5v generator to the A3 or A4 the ADC is reporting considerably lower voltages than what is physically generated and measured using a multimeter.
Also if program an event using IFTTT using the ADC voltage to switch a Digital output it will not trigger the event?
E.G. IF AI3 is <=2.00v THEN DO1 to On if I reduce the voltage to AI3 to less than 2.00v or even drop it down to zero volts DI1 output does not change state.
Also if program an event using IFTTT using the ADC voltage to switch a Digital output it will not trigger the event?
E.G. IF AI3 is <=2.00v THEN DO1 to On if I reduce the voltage to AI3 to less than 2.00v or even drop it down to zero volts DI1 output does not change state.