01-24-2025, 09:16 PM
(09-28-2024, 12:47 AM)admin Wrote: if you download KCS firmware, support DS18B20,DHT11,DHT22 sensors. you can chose any one connect to free GPIO ports.
Done. Thanks.
Now I'm able to read temperature and humidity from DHT11 connected to my A6 board.
At the moment I get this values from the monitor section of kincony firmware.
Next step I'd like to read temperature and humidity data from the same sensor with the same connection to the board A6 but, this time, I need to read data from RS485.
Where to find info about register type, address and so on from wich get data?