Smart Home Automation Forum › Technical Support › KC868-A series and Uair Smart Controller v
Temperature and humidity with A6

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Temperature and humidity with A6
admin Offline
Administrator
*******
Posts: 7,064
Threads: 881
Joined: Oct 2020
Reputation: 171
#8
01-27-2025, 12:50 AM
1-wire sensor not support by KCS firmware modbus protocol.
i suggest you integrate all KC868-A6 board by wifi, so that can config by ESPHome use all hardware resource.
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://shop.kincony.com
Find
Reply


Messages In This Thread
Temperature and humidity with A6 - by Savino - 09-27-2024, 08:49 PM
RE: Temperature and humidity with A6 - by admin - 09-28-2024, 12:47 AM
RE: Temperature and humidity with A6 - by Savino - 01-24-2025, 09:16 PM
RE: Temperature and humidity with A6 - by admin - 01-25-2025, 03:06 AM
RE: Temperature and humidity with A6 - by Savino - 01-25-2025, 07:16 AM
RE: Temperature and humidity with A6 - by admin - 01-25-2025, 07:24 AM
RE: Temperature and humidity with A6 - by Savino - 01-26-2025, 10:16 PM
RE: Temperature and humidity with A6 - by admin - 01-27-2025, 12:50 AM
RE: Temperature and humidity with A6 - by Savino - 01-27-2025, 06:35 AM
RE: Temperature and humidity with A6 - by admin - 01-27-2025, 07:36 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)