4 hours ago
about these, can you take a video of your test process. send to whatsapp number: +86-15381188302 we will test as your video step
>>>>Im trying to register whatsapp but i cannot register because I am not getting verification code.
Also, I explained in detail above what I did and what triggers the bug. Btw, here is the summary:
(1) B16M > MQTT auto discovery - ON
(2) Link B16M to smart life app
(3) Have any entity on HA, on my case is wireless switch ( i name it Dining_light)
(4) Made an automation inside HA, which when Dining_light triggers from on to off (or vice versa), B16M-output1 also triggers to state.state
This is same, if B16M-output1 triggers to on of off, dining_light also triggers. In short I bind the two switch entity so that they will follow each other.
The code was sent here on this thread. Take note that this code is already running on my A16 setup, so im 100% sure nothing wrong on my HA automation code.
I should just replace my A16 to B16M to use voice commands, then I found this bug.
(5) On my set-up, I have 3 entities on HA that is also binded to B16M outputs 1-3.
(6) Go to smart life app, click fast all those entites, fast on off on off on off, after maybe 5 seconds it makes the B16m reboot.
(7) then after it reboots, even you disconnect mqtt and tuya smart like, this bug is embedded on B16M. Click any switch 'once' and it will make the B16m reboot. but, This will solve if i just restore-factory setting or re-flash my board.
I hope I explained it in details.
>>>>Im trying to register whatsapp but i cannot register because I am not getting verification code.
Also, I explained in detail above what I did and what triggers the bug. Btw, here is the summary:
(1) B16M > MQTT auto discovery - ON
(2) Link B16M to smart life app
(3) Have any entity on HA, on my case is wireless switch ( i name it Dining_light)
(4) Made an automation inside HA, which when Dining_light triggers from on to off (or vice versa), B16M-output1 also triggers to state.state
This is same, if B16M-output1 triggers to on of off, dining_light also triggers. In short I bind the two switch entity so that they will follow each other.
The code was sent here on this thread. Take note that this code is already running on my A16 setup, so im 100% sure nothing wrong on my HA automation code.
I should just replace my A16 to B16M to use voice commands, then I found this bug.
(5) On my set-up, I have 3 entities on HA that is also binded to B16M outputs 1-3.
(6) Go to smart life app, click fast all those entites, fast on off on off on off, after maybe 5 seconds it makes the B16m reboot.
(7) then after it reboots, even you disconnect mqtt and tuya smart like, this bug is embedded on B16M. Click any switch 'once' and it will make the B16m reboot. but, This will solve if i just restore-factory setting or re-flash my board.
I hope I explained it in details.