Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KC868, is there some API available for KCS V2 apps on these board
#1
Question 
Dear all
I am on the way to make alive a small watermill in a little town in the East of France.
To do so I plan to use products like Kincony Kc868 Axx series board plus TUYA automation.

At the moment its begin to work using one KC868-A16 and one KC868-A6 both using Tuya scene cloud programmation 
 
However i would like to improve the genuine software capabilities (ie: TUYA capabilities over WIFI) and add some DIY functions using Modbus registers reading and Zigbee sensor reading at the same time plus some control and commands routines of my own done using ie: Arduino ide.
 
My question is How to link your KCS V2 binary with my own routines?
 
Is there some ways to do so on the same board/software?
Is there some specific documented API that should allow that?
What will be the more convenient way to go further and achieve my goals.
 
Some advice would be much appreciated.
I thank you in advance
 
Yours faithfully
Laurent COLIN
Reply


Messages In This Thread
KC868, is there some API available for KCS V2 apps on these board - by magsys - 02-17-2025, 05:42 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)