03-01-2025, 09:52 AM
(03-01-2025, 08:54 AM)twostar Wrote: One other possibility, and this is just guessing, is that the board has the time internally in UTC but applies the (incorrect) time zone offset for display, so the displayed time doesn't matched the internal time. Can you set it to trigger (say) every day at 12pm and then hook up an external monitor to record the time when it actually triggers?
Also, have you enabled the logical AND option? That would change it so all conditions have to be met, not just the time.
Hello. As you can see in the screenshot, I configured only one condition. But to answer you question: no I did not enable the AND condition.
I also tried to set my timer so that it will trigger when UTC +-0 is reached. But this also did not help.
I can try to set up several times to see if it triggers at any point in time.
Does the timer work in an A16 v2.2.10 device on you side?