03-04-2025, 12:51 PM
(03-03-2025, 10:35 PM)admin Wrote: because now esp32 inside is our test firmware.
you need download KCS v2 firmware to use. or you config it by esphome. the USB driver for MAC download at here: https://www.wch-ic.com/downloads/CH341SER_EXE.html
A6 no free GPIO for ethernet module.
Understood, need to flash esphome. However, I don't see any USB device (besides my keyboard and hub) when I connect the KCS.
I tried:
- 3 different known good cables (1 A to C, 2 C to C)
- Connect to hub and connect directly to a port in my computer
- Power cycle, hold button.
According to the instructions for the ch341, I should see a USB device with VID 1a86, but it is not there.
Please advice.