03-23-2025, 05:46 PM
I think the original concern on this specific programming is solved: I just misunderstood that the mosfets bridged `DC` to their OUTPUT pin, rather than their pin with `+` or `-`.
The loads I want to run are 24V DC (no contactor, no relays, no 220V AC). Sorry if I misused a 220V lamp symbol: I'm still very new to all this.
With your wiring diagrams, the last concerns I have are in this other thread: https://www.kincony.com/forum/showthread.php?tid=7860
I'd say that all the provided programming from the original post of this thread is correct / working, once wired correctly, thanks! :-)
The loads I want to run are 24V DC (no contactor, no relays, no 220V AC). Sorry if I misused a 220V lamp symbol: I'm still very new to all this.
With your wiring diagrams, the last concerns I have are in this other thread: https://www.kincony.com/forum/showthread.php?tid=7860
I'd say that all the provided programming from the original post of this thread is correct / working, once wired correctly, thanks! :-)