04-10-2025, 01:46 PM
Board is KC868A16v3 with the latest firmware, 3.9.0. It looks like I can't upload an image directly so here's an indirect link, just +V, GND, and GPIO Pin 1 connected to the DHT22.
The question wasn't about the wiring though, it's that the new v3 interface is different from the v2 one, it looks like you're required to set a GPIO with the choice being 47, 48, and 38. I'm using pin 1 on the GPIO connector, I don't know how that maps to 47, 48, or 38.
The question wasn't about the wiring though, it's that the new v3 interface is different from the v2 one, it looks like you're required to set a GPIO with the choice being 47, 48, and 38. I'm using pin 1 on the GPIO connector, I don't know how that maps to 47, 48, or 38.