12-02-2025, 09:45 PM
I have an e16t controller. Since the purchase, I have been using tuya (factory firmware). I recently decided to try a smart home based on the Home assistant. The Home assistant is installed on Raspberry pi5.
I found a post on the forum that you can install a new configuration file on the e16t (via esphome), which will allow you to control the relay via tuya and home assistant.
I did everything according to the scheme, and I ran into such a problem that esphome does not see the connected e16t device via usb. I used the cable from the e16t kit, I also tried to use another cable, but with no result.
After that I tried to connect e16t to PC (windows), but PC cannot detect e16t. The driver for the ch340c is installed.
Nothing happens when connected to a PC.
Can you tell me how to solve this problem?
I found a post on the forum that you can install a new configuration file on the e16t (via esphome), which will allow you to control the relay via tuya and home assistant.
I did everything according to the scheme, and I ran into such a problem that esphome does not see the connected e16t device via usb. I used the cable from the e16t kit, I also tried to use another cable, but with no result.
After that I tried to connect e16t to PC (windows), but PC cannot detect e16t. The driver for the ch340c is installed.
Nothing happens when connected to a PC.
Can you tell me how to solve this problem?