a16v3 - reed switch and motion sensor connection

[bartasp]

Hi. Module working connected directly to PC via Uart Assistant tool.

But can't call via a16v3 board. Connected to GPIO40 - RX and GPIO41-TX as you maintained in previous comment. Configured as on https://www.kincony.com/forum/showthread...t=sim7600e

Log:
14:27:53 [D] [binary_sensor:047] 'Call Button': ON
14:27:53 [D] [uart_debug:157] >>> "ATD607....;\r\n"
14:27:53 [D] [uart_debug:157] <<< "ATD607....;\r\n"
14:27:57 [D] [binary_sensor:047] 'Call Button': OFF

14:28:02 [D] [binary_sensor:047] 'Call Button': ON
14:28:02 [D] [uart_debug:157] >>> "ATD607....;\r\n"
14:28:02 [D] [uart_debug:157] <<< "ATD607....;\r\n"
14:28:07 [D] [binary_sensor:047] 'Call Button': OFF

Configuration:
# UART configuration for SIM7600E
uart:
  id: uart_2
  tx_pin: GPIO41
  rx_pin: GPIO40
  baud_rate: 115200
  debug:
    direction: BOTH
    dummy_receiver: true
    after:
      timeout: 10ms
    sequence:
      - lambda: UARTDebug::log_string(direction, bytes);


  - platform: gpio
    name: "Call Button"
    on_press:
      then:
        - uart.write:
            id: uart_2
            data: "ATD607....;\r\n"  # Replace with the phone number you want to dial
    pin:
      pcf8574: pcf8574_hub_extra
      number: 3
      mode: INPUT
      inverted: true

  - platform: gpio
    name: "Send SMS Button"
    on_press:
      then:
        - uart.write:
            id: uart_2
            data: "AT+CMGF=1\r\n"  # Set SMS to text mode
        - delay: 1s
        - uart.write:
            id: uart_2
            data: "AT+CMGS=\"607....\"\r\n"  # Replace with the recipient's phone number
        - delay: 1s
        - uart.write:
            id: uart_2
            data: "KinCony-SMS-Sensor\x1A"  # Send the message "KinCony-SMS-Sensor" and terminate with Ctrl+Z
    pin:
      pcf8574: pcf8574_hub_extra
      number: 4
      mode: INPUT
      inverted: true