Z1

[Borg357]

we have many ethernet board, i just want to know, if you connect Z1 by ethernet, what you want do? such as connect with a zigbee sensor? receive RF signal? or send IR signal?

I finally installed another AP board, and I got the Z1 to connect to this board.  Now it's connected to my network, abd I can log in, and save everything fine.

I activate the "MQTT(HA): connected".  It shows connected.

However, when going to HA, it does not show up at all in Home Assistant.  

Since this is a RF/IR only board, do you have to have a learned frequency first, or should it just show up in HA without anything learned yet?

Thanks

-Richard