12-14-2020, 12:48 AM
take a photo how your wire. do you send command by ethernet cable? if it is, you should send command like "DIMMER-SEND-1,53" 1 is channel-1,53 is brightness.
DIMMER-SEND-01,xx is for RS485 port use.
if you want to change IP, find your board's IP, open browser to login, then you can change setting, just like login your router.
DIMMER-SEND-01,xx is for RS485 port use.
if you want to change IP, find your board's IP, open browser to login, then you can change setting, just like login your router.