yes I can write a program but I would understand wich is the possibilities that I have ith you boards
at the moment my pc is connected to I/O module by rs485 , I would make the same with your module but with ethernet and the protocol is completly different
In my actual system I read every input and through my software I can choose which out turn off or on.
I could send you some pictures of my software if you want to see
I would create an http server on a PC and set your cards in server mode to let them communicate with the PC, is this idea correct in your opinion?
I was also thinking of using the rs485 port of the KC868-COLB to control air conditions modbus devices but this too must be done through the PC which is connected through the LAN, is this possible?
at the moment my pc is connected to I/O module by rs485 , I would make the same with your module but with ethernet and the protocol is completly different
In my actual system I read every input and through my software I can choose which out turn off or on.
I could send you some pictures of my software if you want to see
I would create an http server on a PC and set your cards in server mode to let them communicate with the PC, is this idea correct in your opinion?
I was also thinking of using the rs485 port of the KC868-COLB to control air conditions modbus devices but this too must be done through the PC which is connected through the LAN, is this possible?