02-19-2022, 04:34 AM
(02-18-2022, 10:49 PM)ahmedk4444@yahoo.com Wrote: Just i would like to add and correct me if i'm wrong
If the liad of lighting and shutters are 220v - 3-4 A each i suggest Kc868-HxxB
The terminal output can connect to 220 source and control llight and shutters, if your liad or part of it need more than 19A , 16A or more then you need to split the low loads to B type and higher liad to BS type and add the E16 module that contain relay with 12 v coil and use the dry contact for high ampere load.
Or
Use B type for all and high amp load use contactors with 220 v coil.
you are right, if you are using HxB controller , need use by 16A, you can also use KC868-E16 connect to HxB relay output, but this time, let HxB relay output DC12V to control KC868-E16. just use small relay control large relay ON/OFF.