Actually no i wont give up as i now have totally useless h32 boards one is h32L and the other is h32b, whilst trying to troubleshoot the h32b this is what i cannot do.
1, cannot find with vircom
2. cannot connect to rj45
3. cannot connect with usb-serial connector(Worked in the past)
4. while in station mode cannot update firmware.
this is all I can do via wfi
Can configure Station and/or Access point.
when i plug power in I have several red lights saying the relays are on(when they are not)
The board is instantly on when plugging power in.
I have red and green light either side of the RJ45 socket.
Is there anyway to try to recover and reset boards back to default or are they fried?
Shouldn't be as the load is less than 200 watts and doesn't even reach an amp.
This is the second board now that has ended up like this.
Gary
1, cannot find with vircom
2. cannot connect to rj45
3. cannot connect with usb-serial connector(Worked in the past)
4. while in station mode cannot update firmware.
this is all I can do via wfi
Can configure Station and/or Access point.
when i plug power in I have several red lights saying the relays are on(when they are not)
The board is instantly on when plugging power in.
I have red and green light either side of the RJ45 socket.
Is there anyway to try to recover and reset boards back to default or are they fried?
Shouldn't be as the load is less than 200 watts and doesn't even reach an amp.
This is the second board now that has ended up like this.
Gary