Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Help needed/wanted?
#6
(03-08-2022, 02:12 PM)admin Wrote: H32B is new design, different with H32L. H32B never use vircom again, just use ethernet ip address login in web browser to config ethenret and wifi setting.
here is online guide: https://www.kincony.com/how-to-use-kc868...oller.html
after you seen the details, i think you will understand how to do. if also have any questions, you can leave message
[UPDATE] the problem circuit has been tested direct into a 6a MCB as a switch, It switches on and off no problems.

I'm 100% certain no wire have been crossed in the wiring.

Is there anyway you have software i could debug the board and each relay? 

I cannot reset either to start again or update the firmware, What to do?

I'm just about to move into our new kitchen and everything was working fine with the H32B rev 7.2 until I've hit this problem?

Not sure if i have fried the board. Huh

Gary
Reply


Messages In This Thread
Help needed/wanted? - by gay - 03-06-2022, 10:19 AM
RE: Help needed/wanted? - by admin - 03-06-2022, 01:32 PM
RE: Help needed/wanted? - by gay - 03-06-2022, 06:24 PM
RE: Help needed/wanted? - by gay - 03-08-2022, 12:59 PM
RE: Help needed/wanted? - by admin - 03-08-2022, 02:12 PM
RE: Help needed/wanted? - by gay - 03-08-2022, 03:04 PM
RE: Help needed/wanted? - by gay - 03-08-2022, 07:22 PM
RE: Help needed/wanted? - by gay - 03-09-2022, 10:43 AM
RE: Help needed/wanted? - by admin - 03-09-2022, 10:52 AM
RE: Help needed/wanted? - by admin - 03-09-2022, 10:54 AM
RE: Help needed/wanted? - by gay - 03-09-2022, 11:22 AM
RE: Help needed/wanted? - by admin - 03-09-2022, 11:35 AM
RE: Help needed/wanted? - by admin - 03-09-2022, 11:37 AM
RE: Help needed/wanted? - by gay - 03-10-2022, 12:49 PM
RE: Help needed/wanted? - by admin - 03-10-2022, 12:57 PM
RE: Help needed/wanted? - by gay - 03-10-2022, 01:33 PM
RE: Help needed/wanted? - by gay - 03-10-2022, 02:57 PM
RE: Help needed/wanted? - by admin - 03-10-2022, 01:48 PM
RE: Help needed/wanted? - by admin - 03-11-2022, 12:31 AM
RE: Help needed/wanted? - by gay - 03-11-2022, 10:40 AM
RE: Help needed/wanted? - by admin - 03-11-2022, 12:51 PM
RE: Help needed/wanted? - by gay - 03-13-2022, 01:37 PM
RE: Help needed/wanted? - by admin - 03-14-2022, 01:23 AM
RE: Help needed/wanted? - by gay - 03-14-2022, 09:28 AM
RE: Help needed/wanted? - by admin - 03-14-2022, 11:11 AM
RE: Help needed/wanted? - by admin - 03-14-2022, 11:12 AM
RE: Help needed/wanted? - by gay - 03-14-2022, 12:18 PM
RE: Help needed/wanted? - by admin - 03-14-2022, 12:44 PM
RE: Help needed/wanted? - by gay - 03-14-2022, 12:50 PM
RE: Help needed/wanted? - by admin - 03-14-2022, 01:09 PM
RE: Help needed/wanted? - by gay - 03-14-2022, 01:40 PM
RE: Help needed/wanted? - by admin - 03-14-2022, 08:31 PM
RE: Help needed/wanted? - by masoos - 06-14-2022, 09:05 PM
RE: Help needed/wanted? - by admin - 06-14-2022, 10:44 PM
RE: Help needed/wanted? - by Scansat - 07-30-2022, 04:40 PM
RE: Help needed/wanted? - by admin - 07-30-2022, 10:15 PM
RE: Help needed/wanted? - by Scansat - 08-03-2022, 01:01 AM
RE: Help needed/wanted? - by admin - 08-03-2022, 03:25 AM
RE: Help needed/wanted? - by Scansat - 08-03-2022, 02:51 PM
RE: Help needed/wanted? - by admin - 08-03-2022, 03:11 PM
RE: Help needed/wanted? - by Scansat - 08-03-2022, 05:18 PM
RE: Help needed/wanted? - by admin - 08-03-2022, 10:56 PM
RE: Help needed/wanted? - by Scansat - 08-04-2022, 07:12 AM
RE: Help needed/wanted? - by admin - 08-04-2022, 11:15 AM
RE: Help needed/wanted? - by Scansat - 08-04-2022, 01:48 PM
RE: Help needed/wanted? - by admin - 08-04-2022, 09:45 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)