K868-Uair proper GPIO assignation ?

[vincen]

Hi

I'm tyring to use a K868-Uair with ESPHome but I have some problems ! According at Kincony ducomentation it should GPIO32 and 33 to control RGB LEDs of bottom ring and vertical bar ! Unhappy these two GPIOs are doing exactly the same thing: control the ring only and only 3 LEDs of it
Someone has the proper GPIO configuration of that board ?
Noticed also that the Dallas temperature sensor is a chinese copy I think as it's 4/5° offset of other temperature sensors I have in the room

Code used so far in ESPHome for LEDs:

Code:

light:
  - platform: neopixelbus
    type: GRB
    variant: WS2812X
    pin: GPIO33
    num_leds: 4
    name: "Barre"
  - platform: neopixelbus
    type: GRB
    variant: WS2812X
    pin: GPIO32
    num_leds: 4
    name: "Ring"

Thanks for help

Vincèn