05-12-2022, 09:05 PM
(This post was last modified: 05-12-2022, 09:10 PM by dmshimself.)
(05-12-2022, 12:53 PM)admin Wrote: here is config file for IR receiver.
Thanks for supplying that. There is a different ESP type in this config to the reference one on the web site, so I'll stick with the one you have supplied. If I just use your config, adjusting as needed for my wireless, then it works. That is great news. As soon as I add in the buzzer, lights etc from that section of the web site config, it stops working. I'll spend some time gradually adding things in until I see which ones cause the problem and report back.
(05-12-2022, 01:27 PM)admin Wrote: here is ESPHome config file for RF 433MHz receiver decode.
Again thanks for this one and I applied this config, but without pressing any buttons on my RF remote, data is displayed continuously, so I modified the dump all in your config to just dump rc_switch and that allowed me to just see button presses. It's like there is RF noise being registered by the device all the time. Is there a way to stop this from happening? As with the IR, I'll gradually put in the other config for the other devices. Many thanks for the assist.