05-12-2022, 09:44 PM
(05-12-2022, 09:34 PM)admin Wrote: because there are many wireless signal in air, suggest use RC-switch. ESPHome official website also showed about this question:
Note:
If the log output is flooded with “Received Raw” messages, you can also disable raw remote code reporting and rely on rc_switch to decode the values.
https://esphome.io/components/remote_tra...ting-up-rf
I found that ESPHOME comment previously which is why I changed the dump all. But I only have 2 RF transmitters and neither were in use during my test. My house is way out in the country, so there will not be any other RF devices interfering from neighbours. Is there a way to reduce the sensitivity of the RF receiver? An answer of 'No' is quite ok and just saves me continuing to look.