[Arduino demo source code for KC868-A4]-11 how to create wifi connection

[masoos]

Hello,I have a problem.....wrecked my A4 board with this code.....

I uploaded this code (while I forgot to change the SSID / Password) and the code was uploaded fine by COM10.Then suddenly COM10 disconnected.

Its stays disconnected. Windows does not show COM10 anymore.
I press Reset...voila...com10 connects...
BUT if I release the Reset button, COM disconnects.

I rebooted windows...no difference :-) 
IDE only detects board, while I press reset button (but during this I cannot reflash code)
If I release reset...board is gone

---

Hello,I have a problem.....wrecked my A4 board with this code.....

I uploaded this code (while I forgot to change the SSID / Password) and the code was uploaded fine by COM10.Then suddenly COM10 disconnected.

Its stays disconnected. Windows does not show COM10 anymore.
I press Reset...voila...com10 connects...
BUT if I release the Reset button, COM disconnects.

I rebooted windows...no difference :-) 
IDE only detects board, while I press reset button (but during this I cannot reflash code)
If I release reset...board is gone

I found solution.

open other code and flash again....in the "connecting ........." info wait till 80% progress is made and then release reset button. If you are happy with the timing, the new code starts flashing before windows is closing COM Port