Smart Home Automation Forum › Technical Support › KC868-A4 v
[Arduino demo source code for KC868-A4]-11 how to create wifi connection

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
[Arduino demo source code for KC868-A4]-11 how to create wifi connection
masoos Offline
Junior Member
**
Posts: 9
Threads: 2
Joined: Jun 2022
Reputation: 0
#6
08-15-2022, 10:25 AM (This post was last modified: 08-15-2022, 11:04 AM by masoos.)
(08-15-2022, 03:24 AM)admin Wrote: can you change a USB cable for a test.
did, no effect
(08-15-2022, 10:25 AM)masoos Wrote:
(08-15-2022, 03:24 AM)admin Wrote: can you change a USB cable for a test.
did, no effect

It only works, if I connect Pin 14 on the CH340 (RTS) to GND....the USB is connected. 
What is nomal level on RTS without Reset? Is it Low or high?. I have a high (3,16V) 

Thanks
Find
Reply


Messages In This Thread
RE: [Arduino IDE demo source code for KC868-A4]--#11-WIFI connect - by masoos - 08-15-2022, 10:25 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)