12-28-2020, 10:14 PM
Hi,
I purchased a KC868-D8-Dimmer Controller and attached it to the network. Then I used the KBOX Smart App to control a lamp attached to Output-Channel 1. Then I wanted to use my switches to increase or decrease the brightness. Well, this is where the problem starts. I connected K1+ and K1- to switch one and K2+ and K2- to switch two as described on your page Dimmer Product Page, especially the diagram at https://www.kincony.com/images/KC868-D8/...mmer-6.png
![[Image: kc868-d8-dimmer-6.png]](https://www.kincony.com/images/KC868-D8/kc868-d8-dimmer-6.png)
Unfortunately, the controller does not react at all. It is just ignoring if I press the switch or not. Then I started some research and found your YouTube video
There you used 5 wires and not four. I do not exactly know how everything is connected
I attached a photo of how I connected everything (test phase, no soldering used). Do you know what I am doing wrong?
Thanks, iwzr
I purchased a KC868-D8-Dimmer Controller and attached it to the network. Then I used the KBOX Smart App to control a lamp attached to Output-Channel 1. Then I wanted to use my switches to increase or decrease the brightness. Well, this is where the problem starts. I connected K1+ and K1- to switch one and K2+ and K2- to switch two as described on your page Dimmer Product Page, especially the diagram at https://www.kincony.com/images/KC868-D8/...mmer-6.png
Unfortunately, the controller does not react at all. It is just ignoring if I press the switch or not. Then I started some research and found your YouTube video
There you used 5 wires and not four. I do not exactly know how everything is connected
I attached a photo of how I connected everything (test phase, no soldering used). Do you know what I am doing wrong?
Thanks, iwzr