01-05-2021, 12:41 AM
1.after your download the firmware, you click "RUN" button on the download tool or re power on, after 5 seconds will begin to work.
2.you press "Refresh" button for read data or use "autoreport" funtion? if "Refresh" , you can set the time for 2000ms. if use "AutoReportON" , you need set the "variation value".
3. firmware version is seen in the KC868-COL PC software window. Not in vircom tool window, that version is the ethernet module version, not for COL's.
2.you press "Refresh" button for read data or use "autoreport" funtion? if "Refresh" , you can set the time for 2000ms. if use "AutoReportON" , you need set the "variation value".
3. firmware version is seen in the KC868-COL PC software window. Not in vircom tool window, that version is the ethernet module version, not for COL's.