10-09-2022, 11:56 AM
Hello
I have 3 KC868-A16 boards. All ESPHome on Homeassistant.
1 board doesnt restart properly after config change and sending it via OTA. Sometimes it restarts properly, sometimes no.
When it fails, both ethernet lights flash on and off. Power cycle resets board and works fine.
When I delete board from ESPHome and add a new board, 1st time compile and OTA works ok. If I add another PIN, recompile and send via OTA, both ethernet lights flash and I have to power cycle board.
I have tested changes, OTA and restarts on other 2 boards, works ok.
Can you please assist.....this is a new board.
Thankyou..Peter
I have 3 KC868-A16 boards. All ESPHome on Homeassistant.
1 board doesnt restart properly after config change and sending it via OTA. Sometimes it restarts properly, sometimes no.
When it fails, both ethernet lights flash on and off. Power cycle resets board and works fine.
When I delete board from ESPHome and add a new board, 1st time compile and OTA works ok. If I add another PIN, recompile and send via OTA, both ethernet lights flash and I have to power cycle board.
I have tested changes, OTA and restarts on other 2 boards, works ok.
Can you please assist.....this is a new board.
Thankyou..Peter