KC868-COL

[ELIO]

1.after your download the firmware, you click "RUN" button on the download tool or re power on, after 5 seconds will begin to work.

2.you press "Refresh" button for read data or use "autoreport" funtion? if "Refresh" , you can set the time for 2000ms. if use "AutoReportON" , you need set the "variation value".



3. firmware version is seen in the KC868-COL PC software window. Not in vircom tool window, that version is the ethernet module version, not for COL's.

Hello Admin

Excuse me but till now i can't connect my KC868 COL. i describe you step by step how i am trying to connect it.

1- The COL and the PC are connected to the Router. via cables.
2- I lunch vircom and find the IP of the device. I put DHCP Mode and TCP SERVER.
3- I lunch the PC controller software and enter the IP shown in the vircom and also the port.
The controller is not connecteted the board version of the controller is not shown and it will disconnect automatically after several seconds. 

Also if you can tell me how to upgrade the firmware of the controller and which software i have to use to install the upgrade version.