Can other types of temp/humidity sensors be used such as DHT22 and SHT-C3?
--> sure, just use 1-wire sensor for KC868-A6 board is ok, just tasmota firmware supported.
Since Tasmota already has the libraries for the two you mention, is there a way to update Tasmota or does Kincony provide additional 868-A6 updates?
--> Tasmota always update firmware, you can download firmware from tasmota official webpage.
I followed your instructions and works with the two sensors you indicated. I then tried two DS18B20 temp probes changing the configuration table to show 32/33 as DS1820. Only one shows up, why?
--> do you use two DS18B20 with 2 GPIOs or 1 GPIO?
--> sure, just use 1-wire sensor for KC868-A6 board is ok, just tasmota firmware supported.
Since Tasmota already has the libraries for the two you mention, is there a way to update Tasmota or does Kincony provide additional 868-A6 updates?
--> Tasmota always update firmware, you can download firmware from tasmota official webpage.
I followed your instructions and works with the two sensors you indicated. I then tried two DS18B20 temp probes changing the configuration table to show 32/33 as DS1820. Only one shows up, why?
--> do you use two DS18B20 with 2 GPIOs or 1 GPIO?