01-16-2023, 01:09 PM
1. can you take a screen photo of your network setting webpage? i want to see your H32BS firmware version and how you set in relay recovery option.
2. 1-32 DI (green terminal) can use for control output ON/OFF, there is an option in network setting webpage called "SW trigger output". if you enable it, 1-32 DI can control output directly, will not send mqtt message. if you disable it, when you trigger input, will feedback mqtt message.
1-6 DI(blue terminal) manly use for sensor, so it will feedback DIx mqtt message.
"Basically the "relay1, relay2,..." is disappearing from the state value and becomes D1, D2, D3... This generates tons of errors 3000 errors in 2 hours."
i don't understand this, can you take photo video.
2. 1-32 DI (green terminal) can use for control output ON/OFF, there is an option in network setting webpage called "SW trigger output". if you enable it, 1-32 DI can control output directly, will not send mqtt message. if you disable it, when you trigger input, will feedback mqtt message.
1-6 DI(blue terminal) manly use for sensor, so it will feedback DIx mqtt message.
"Basically the "relay1, relay2,..." is disappearing from the state value and becomes D1, D2, D3... This generates tons of errors 3000 errors in 2 hours."
i don't understand this, can you take photo video.