02-02-2023, 10:24 PM
[attachment=1859 Wrote:admin pid='5322' dateline='1672280968']You can use this network tool update KC868-H32B Pro controller by ethernet cable.
I tried to use the network tool update with my KC868-H32B Pro and I couldn't get it to work. The target IP can't be changed, so I tried using a static IP with my H32B Pro set to the target IP of 192.168.1.200 and then I connected an ethernet cable from the H32B Pro to a small ethernet switch and connected my MacBook Pro M1 to it as well via CAT5. I set my MacBook Pro's IP Address to 192.168.1.1 and I was able to pull up the device's web interface using 192.168.1.200. When I tried the tool under Windows 11 using Parallels, I was able to "Try to ping device" successfully. When I clicked "Connect", I got what I assume was an error message in Chinese that I couldn't understand:
It would be great if we could just "Upload New Firmware" directly on the web interface instead...
What does the error message mean?
Mark