02-21-2023, 01:14 AM
usually have "Digital input" and "Analog input" for a PCB board.
"Digital input" means signal is HIGHT or LOW for CPU. maybe input=0v, maybe input=12v.
"Dry contact" means just only a OPEN/CLOSE signal, such as two wire SHORT or NOT SHORT for two state. it no power voltage, only OPEN/CLOSE.
for KinCony's board, you can use "Dry contact" signal connect to "Digital input" port, because there have 12v circuit for the INPUT circuit.
"Digital input" means signal is HIGHT or LOW for CPU. maybe input=0v, maybe input=12v.
"Dry contact" means just only a OPEN/CLOSE signal, such as two wire SHORT or NOT SHORT for two state. it no power voltage, only OPEN/CLOSE.
for KinCony's board, you can use "Dry contact" signal connect to "Digital input" port, because there have 12v circuit for the INPUT circuit.