Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
how to enable the USB ports on Raspberry Pi CM4
#6
(02-27-2023, 07:40 AM)admin Wrote: can you use another new SD card install home assistant OS, have a test?

I tried using an SD chip early on to no avail, the server would not discover the chip or boot from it.  tried several different chips all verified on a different computer.  I put an ssd drive in the usb c and 2.0 usb which do not read the drives for boot either.  I wouldn't care about any of these issues if I could just get to the config.txt.  It looks like I have a defective unit centered around the SD card and eMMC pathways.  I have an anydesk id if you would choose to reach out and verify...we can do a video chat and you can watch me go through the steps.  It might be a long drawn out process, but we can wipe it all and stat from scratch, AGAIN.
Reply


Messages In This Thread
RE: how to enable the USB ports on Raspberry Pi CM4 - by Mauscom - 02-27-2023, 04:16 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)