Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
"KCS" ADC SENSOR SET UP IN HOME ASSISTANT
#16
Good day
Im Using KCS firmware but on the DAC outpu1 I cannot get any voltage reading when I measure the volts. Also in tuya smart if I change the value of the DAC in the slider it tells me failed to save.

What can I do?
Reply


Messages In This Thread
RE: "KCS" ADC SENSOR SET UP IN HOME ASSISTANT - by benlouisv@gmail.com - 03-19-2023, 08:51 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)