03-25-2023, 05:04 AM
To turn on the nextion monitor, it was necessary to feed it with 5V. These pins of the kincony A6 board would ideally receive 3.3V
Why was there no concern with the voltage applied to make an RX TX communication from the monitor to pins A12 and A13 of the kincony A6 board?
The communication of both is being 5V. Correct me if I reached the wrong conclusion.
Why was there no concern with the voltage applied to make an RX TX communication from the monitor to pins A12 and A13 of the kincony A6 board?
The communication of both is being 5V. Correct me if I reached the wrong conclusion.