Smart Home Automation Forum › Technical Support › KC868-A16 v
RS485 not receiving anything

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
RS485 not receiving anything
admin Offline
Administrator
*******
Posts: 6,323
Threads: 808
Joined: Oct 2020
Reputation: 155
#8
03-31-2023, 02:11 PM
about OUTPUT relay state update, just use by these config. that means every 3 seconds refresh OUTPUT status for home assistant dashboard. you can change the interval time.

modbus_controller:
- id: h32bs
address: 1
modbus_id: modbus1
update_interval: 3s
YouTube: https://www.youtube.com/c/KinCony
Online Store: https://kincony.aliexpress.com
Find
Reply


Messages In This Thread
RS485 not receiving anything - by victorclaessen - 03-28-2023, 03:53 PM
RE: RS485 not receiving anything - by admin - 03-29-2023, 12:20 AM
RE: RS485 not receiving anything - by admin - 03-31-2023, 04:55 AM
RE: RS485 not receiving anything - by admin - 03-31-2023, 01:21 PM
RE: RS485 not receiving anything - by admin - 03-31-2023, 02:11 PM
RE: RS485 not receiving anything - by admin - 04-11-2023, 01:24 PM
RE: RS485 not receiving anything - by admin - 04-12-2023, 06:19 AM
RE: RS485 not receiving anything - by admin - 04-19-2023, 12:54 AM
RE: RS485 not receiving anything - by admin - 04-20-2023, 06:34 AM
RE: RS485 not receiving anything - by admin - 05-01-2023, 11:45 AM
RE: RS485 not receiving anything - by Yocee - 01-14-2024, 03:35 PM
RE: RS485 not receiving anything - by aucirc - 10-06-2024, 03:36 PM
RE: RS485 not receiving anything - by admin - 10-07-2024, 01:10 AM

Forum Jump:


Users browsing this thread:
1 Guest(s)