How to program switch 1 to change relay 1 state - KC868-H8

[martlima]

Here is firmware of KC868-H8 relay controller have sent to your email.  input control output version, but alarm sensor will never be used.
here is video how to do: https://youtu.be/MI2_qAIEt2U

Here is st link tool for KC868 smart controller firmware update.
https://www.kincony.com/download/sttoolset.zip
when download at stlink software , MCU chip chose: 103X8 when update KC868-H8 controller.

ST-link usb cable:
https://www.aliexpress.com/item/33023499...6c0aj9FLgb

Hello.

Thank you very much for your attention.

I received the firmware and successfully upgraded it.



The operation of the input ports has been changed as expected.

However, if I keep the button pressed for more than 500ms (approximately), multiple shots will occur, and this is a very short time.

Is there a way to configure it as a single trigger for each time the button is pressed, regardless of the time it is pressed, or as a second alternative, to increase that multiple trigger time?

I will cable my house, and these input ports will be directly connected (not so directly, I will create some way to improve isolation) to the wall switches throughout the house, so multiple trigger are not interesting.


Thank you again.