06-11-2023, 03:37 PM
So I downloaded version 2.7 again and the same situation happened. No modbus and no mqtt data is sent. Cannot read modbus data even with Kincony Smart Board Controller. In MQTT Explorer no mqtt data is received even when short DI with GND, mqtt no feedback. I have attached some photos from all the configuration.
After this I've reverted the firmware back to v1.14 and immediately received mqtt data. The problem is that now with 1.14 modbus data cannot be read. I've tried in node-red and in Kincony SBC.
Hope you can help. Thank you.
After this I've reverted the firmware back to v1.14 and immediately received mqtt data. The problem is that now with 1.14 modbus data cannot be read. I've tried in node-red and in Kincony SBC.
Hope you can help. Thank you.