Smart Home Automation Forum › Technical Support › KC868-A2
Which GND to use for sensors ?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Which GND to use for sensors ?
primeroz Offline
Junior Member
**
Posts: 12
Threads: 5
Joined: Apr 2023
Reputation: 0
#1
06-23-2023, 01:58 PM (This post was last modified: 06-23-2023, 02:07 PM by primeroz.)
Hi, the only GND i see on the A2 is the one also used for POWER IN


I want to connect a PIR , i can take the `3v3` from the board but i am not sure which GND to use . Should i use the same as the `INPUT power` ?
example diagram of what i want to do


Attached Files Image(s)
   
Find
Reply


Messages In This Thread
Which GND to use for sensors ? - by primeroz - 06-23-2023, 01:58 PM
RE: Which GND to use for sensors ? - by admin - 06-23-2023, 10:39 PM

Forum Jump:


Users browsing this thread:
1 Guest(s)