I erased and loaded the 2.0 twice.
Many issues:
-the monitor is not updated at all
-mqtt is enabled, I see it on mqtt explorer, but the mqtt led on the monitor is still off
- same for the other protocols, enabled but their led stays off
-relays commands on the monitor frame does not operate
- inputs, when shortened, led is on, but monitor led stays off.
- No more update of analogic sensor (on channel4). It is only when the system restarts that there is an channel4 update
- 1wire sensor : no change compared to V1, the monitor page includes it, but no measure is reported, Also this sensor does not show up in the mqtt frame
{"input1":{"value":false},"input2":{"value":false},"input3":{"value":false},"input4":{"value":false},"output1":{"value":false},"output2":{"value":false},"output3":{"value":false},"output4":{"value":false},"adc1":{"value":0},"adc2":{"value":0},"adc3":{"value":0},"adc4":{"value":670},"dac1":{"value":0},"dac2":{"value":0}}
Something is wrong. Was it tested ok on your side?
Many issues:
-the monitor is not updated at all
-mqtt is enabled, I see it on mqtt explorer, but the mqtt led on the monitor is still off
- same for the other protocols, enabled but their led stays off
-relays commands on the monitor frame does not operate
- inputs, when shortened, led is on, but monitor led stays off.
- No more update of analogic sensor (on channel4). It is only when the system restarts that there is an channel4 update
- 1wire sensor : no change compared to V1, the monitor page includes it, but no measure is reported, Also this sensor does not show up in the mqtt frame
{"input1":{"value":false},"input2":{"value":false},"input3":{"value":false},"input4":{"value":false},"output1":{"value":false},"output2":{"value":false},"output3":{"value":false},"output4":{"value":false},"adc1":{"value":0},"adc2":{"value":0},"adc3":{"value":0},"adc4":{"value":670},"dac1":{"value":0},"dac2":{"value":0}}
Something is wrong. Was it tested ok on your side?