07-04-2023, 02:09 PM
I have just checked the board and switch with multimeter, when relay is ON the control voltage output is 12V.
But the wall switch panel is supplied with 0V the LED is ON and OFF when supplied with 12V.
Is there any work around with yaml file, like inverted: true/false, Pull Up / Pull Down options etc. I am not the expert here, so suggest if there is options with touch switch until i get momentary switch in my next order.
But the wall switch panel is supplied with 0V the LED is ON and OFF when supplied with 12V.
Is there any work around with yaml file, like inverted: true/false, Pull Up / Pull Down options etc. I am not the expert here, so suggest if there is options with touch switch until i get momentary switch in my next order.