Hello,
Its me again! I bought this development board and need some help with scripting in Arduino IDE.
Maybe I missed out something, but I think my project may be useful and for other users.
I want to make KC868-AM to be able to receive requests to activate build in Relay (15) (for alarm siren) and all other GPIO pins (5, 13, 14, 33, 36, 37, 38, 39, 34) act as an input (for basic alarm system magnetic NO switch and motion sensors).
Output (Relay) and inputs should be able so receive/send notifications from/to SmartHome server over MQTT.
The device itself should be able to connect to network via LAN or WiFi.
Can someone help with the project?
Its me again! I bought this development board and need some help with scripting in Arduino IDE.
Maybe I missed out something, but I think my project may be useful and for other users.
I want to make KC868-AM to be able to receive requests to activate build in Relay (15) (for alarm siren) and all other GPIO pins (5, 13, 14, 33, 36, 37, 38, 39, 34) act as an input (for basic alarm system magnetic NO switch and motion sensors).
Output (Relay) and inputs should be able so receive/send notifications from/to SmartHome server over MQTT.
The device itself should be able to connect to network via LAN or WiFi.
Can someone help with the project?